We took off the mizzen boom and disconnected the antennas and radar which meant Russ had to climb the mizzen. We replaced three hatch covers with new tinted plexiglass. Russ continued to work on installing the water maker. He has a few more electical connections and that project will be complete. In the mean time the boat is totally torn apart on the inside. Walking around with floor boards up is quite a balancing act. The refrigeration experts are in the process of reinsulating our old well frig, rebuilding our upright frig and enlarging it, and installing a freezer under the starboard settee. We are having two Frigoboat keel coolers installed which should be energy efficient and give us plenty of space for storing foods that need to be cool and frozen.
While Russ worked on the watermaker, I fired up the computer and started listing all of the boat's equipment with model numbers and serial numbers. Apparently, this is important to have in case the property is ever stolen it is easier to recover. We were going to take the boat over to the boat yard on Sunday afternoon, but the wind was blowing 40 knots and would have been difficult to handle and dock single handed (I would be ferrying the car to the boat yard). The last time we did this in a high wind, it took two dockhands from KKMI to tie the boat down. No one would be there on Sunday afternoon to give us a hand so we decided to wait until Monday morning. We got up early on Monday, disconnected the electricity and water. Russ left early Monday a.m. It takes about 10 minutes to drive and 1 hour and 20 minutes to motor the boat from the Emery Cove Marina to KKMI in Richmond. We left the boom and main sail intact in the event of an engine failure. Russ checked his beautifully refurbished engine and pristine engine room half way through the short journey and everything looked and sounded fine. When he pulled into the slip at the dockyard, there was a lot of exhaust smoke/steam coming out the back.
Holy smoke! The hose clamp from the exhaust hose wasn't tightened enough and slipped down sometime between half-way and the end of the short hop; but in that short time, the entire engine room was covered with diesel soot and saltwater. Needless to say, we had our work cut out for us. We weren't expecting to spend the entire rest of the morning scrubbing an cleaning, but that's exactly what we did. What a mess and it still needs more scrubbing. Russ was heartsick. Fortunately, there was no real damage. Russ got some better clamps and cranked them down...a lesson learned.
Once we got the engine room cleaned up, we took off the main sail, boom and vang, unscrewed saftey pins and screws in the turn buckles, and did as much of the prep as we could. Both of the masts will be removed during the haul out. Russ will be stringing new radio wire and antenna wire. We would also like to install a multi-directional night vision video cam on the top of the main mast and brackets on the mizzen mast for a wind generator. Of course I will have the scrub brush out. Seems to be my new lot in life. Two days into retirement and I've broken every nail (not that I had that much anyway), so I cut them way down and filed them close to the skin. We are going to have to invest in a lot of rubber gloves.
The boat was hauled late in the afternoon. The bottom paint still looked good, but there were a lot of critters and growth on the props and zincs that will need to be cleaned off and brushed. Russ is looking forward to cleaning and polishing the hull. While out of the water we will have the boat surveyed for insurance purposes. Hopefully if all goes well, we will be back in the water in two or three weeks and finish up with the Hydrovane, wind generator, and solar panels. The list is getting shorter, but so much to do.
Our list of vicarious sailors is growing! Hey jbarker0 are you out there? You left a comment for us on the last blog, but we had no way of contacting you since you had not established a profile. For a response, check out our return comment on the same blog. We love to hear from folks and are happy to answer your questions, but will have to do so on the comment section if you don't provide us with an email address or establish a profile. One month and 30 days from our sail away. We'll keep you posted. Wishing you a fresh breeze.
G'day Mates,
ReplyDeleteSorry about your little mishap with the exhaust hose but a lesson to we who are yet to get involved. Well, I have to tell you I'm a bit new to this blogging lark so I can't find your reply to my email so you might be able to point me in the right direction. I updated my profile with a picture (you can use it to scare small children) but I haven't a clue how to communicate on it. I really like the idea of the keel cooling for the refrigeration....no worries 'bout the cooling water injesting a plactic bag when you aren't looking. Probably boreing for you but I am really interested in the mods Russ is making.... is that him in the background saying "why doesn't he come over & get a closer look..... I'll give him plenty to do!"... some great info for me.
It is good to pick up ideas from someone who has the same boat as I want though.
Keep up the great blog.. especially with the pictures... makes me feel I'm right there!
kindest regards,
JB.